B.E.G. Brï¿½ck Electronic GmbH

PP-A

PP-1

24V sensor power pack, switching, RJ-12 port for sensor connection
Economical power pack that provides power and switching control to B.E.G. low voltage occupancy sensors and photosensors.
Suitable for parallel connection of one mandatory primary and maximum four optional secondary sensors to increase detection coverage.
Integrated manual (vacancy)/automatic (occupancy) mode switch
LED status and fault indicators
Â½ inch trade size threaded nipple with two lock nuts included.
Switch input to toggle lighting load relay/override sensor (normally-open momentary dry contact)
RJ-12 sensor port. Splitter accessory available to connect multiple sensors. See ordering information.
Integral short circuit and thermal protection
5 years limited warranty
ROHS compliant
Applications:
Use with integral low voltage fixture motion or photo sensor
Motion/photocell switching control of lighting loads (LED, fluorescent, tungsten)
Occupancy sensor switching control of small motors (i.e. restroom ventilation fan)
Occupancy sensor switching control of receptacles
Vacancy sensor application (requires a wall switch manual on)
Sensor application requiring a wall switch override
Sensor application requiring a dry contact input from a control system
Vacancy (Manual) operation is achieved by combining the PP-1-J power pack with a low voltage momentary contact switch and setting the integral mode switch to â€œmanualâ€.

Power pack PP-1-J

97036

Power supply: 120 - 277 V 50 /60 Hz
Power output: 24 V DC/200 mA (Class II)
Control input: 24 V DC/4mA
1 control input. Normally-open momentary contact switch or dry contact closure.
Operating temperature:
-4 Â°F to 122 Â°F / -20 Â°C to +50 Â°C
UV- and shock resistant 5VA material
Compliances: ETL listed for the U.S. and Canada (UL STD 60730-1 and CSA STD E60730-1). UL 2043 plenum rated.
Switching power: max 20A @277 V AC 50/60 Hz
1hp @277VAC 50/60 Hz